As we all know, when we use a computer quilting machine, there will always be some machine failures, which makes us very annoyed. We still need to find a solution and then take the right medicine. We also need to know why this happens, so as not to repeat it again occur. Next, the editor will give you a detailed introduction to the failures we may encounter when using the computer quilting machine. If you are interested, you can follow the editor to find out.

Analysis of the reasons for the broken thread of the computer quilting machine: the needle has a burr or a rough surface; the thread clamp is not adjusted well; there is a burr at the hook hook and thread passing position; The convex head is not smooth, it is easy to cause needle breakage; the jumper link in the sewing machine head is loose; there is a gap between the machine head and the hook frame.

All of the above may cause the computer quilting machine to break, so we have encountered the problem of the computer quilting machine being disconnected. Next, the editor will introduce several solutions for you in detail, hoping to bring you more reference value.

Solution:

1. Adjust the tension so that the bottom thread transfer point is in the middle of the sewing material;

2. Polish and smooth with sandpaper;

3. Polishing and polishing the connection points of the rotary shuttle;

4. Adjust the gap and polish the convex part of the positioning groove;

5. Adjust and tighten the screws;

6. Adjust the meshing clearance of the spiral bevel gear or adjust the synchronous belt tensioner of the upper and lower main drive shafts.

There is also a situation where the computer quilting machine skips stitches. This is also something that makes us all crazy when using computer quilting machines. Of course, there are causes for any results. Then what is the reason for the computer quilting machine to skip stitches? What caused it? Some friends may have encountered this situation and know more about it. However, the editor also summarized some of the causes and solutions for everyone, you can come to understand.

The causes of jump stitches of computer quilting machine: the hook tip is blunt; the needle is bent; the thread twist is too heavy and the elasticity is too large; the raw material of the quilting is uneven, the material is hard; the presser foot bowl * surface is away from the needle board Too large.

Solution: Adjust the initial position and stroke of the presser foot; replace the needle; replace the high-quality cotton thread; flatten the quilting material to remove hard debris; replace the rotary hook.

Good quilting machine equipment should also have a high degree of automation. When purchasing and debugging, you should pay attention to its automation function and its flexibility to ensure that the equipment can automatically complete the sewing operation set before.

We have learned so much about some problems encountered in the use of computer quilting machine, and everyone can solve it according to the causes and solutions of the above faults. Of course, if you encounter other problems in the process of using, you can directly contact our Huaxian Mahe Machinery Factory, we will be happy to solve your doubts for you.