The packaging process of the baler is composed of four steps: feeding, tightening, cutting and pasting.

During the belt feeding process, the belt feeding wheel rotates counterclockwise, and the friction force between the toothed belt wheel and the packing belt is used to make the packing belt feed forward along the packing belt until the end of the packing belt meets the micro switch of the belt stopper , So that the packing belt feeding belt stops and is in the position to be packed.

During the tightening process of the packing belt, the right claw presses up to hold the belt end, and the belt feeding wheel rotates clockwise. The friction force is also used to make the packing belt retreat along the track frame. Loosen under the action of pulling force, so that the packing belt continuously withdraws until it is close to the surface of the package, and the tensioning arm swings downwards accordingly, completely tightening the packing belt.

The next step is the cutting and ironing process. The left paw rises and the two layers of packing tape are pressed. The isolation table exits and the ironing head follows up. It begins to heat the two ends of the packing tape. This is the pressure block rising to cut the packing tape.

Finally, the paste process. The scalding head withdraws from the actual position, and the pressure block continues to rise, pressing the two layers together with the heated packing belt to complete the packing action.